In this video it take the existing filament sensor which has a habit of catching and replace it with a modified version which works a lot better. I go through the installation and design process of how this modification was made.
Hello everybody and welcome to the 3D printer Modding series. In today’s video we’ll take the notorious filament runout sensor that comes with the CR10 V3 and modify it to be more fluid in how it lets filament pass through it. I also have a follow up video which addresses a proper cable guide for the hot end so keep an eye our for that video in the future. As always, please do this mods at your own risk and I’m in no way responsible for any damages that may occur.
So as i mentioned in my previous review of the Creality CR10 V3, the sensor was very much holding back the potential for this machine. Because of the initial design for the filament intake, it caused a severe amount of friction to occur which in some instances prevented the proper flow of filament through the nozzle. Before trying to create a new housing i did run a test to see if I could simply replace the existing sensor with one that I had lying around however this produced an error which prevented the printing process from starting. Instead of modifying the firmware, I decided to change the housing which I believed to be the main cause of the issue. The electronics themselves were very well designed so doing this also make this modification easier for other’s to undertake.
So the very first step was to the remove the existing component and open it up to see what was inside. Luckily, this was fairly easy to accomplish because of how it was assembled on the machine. Once you remove the 4 screws holding it in place you are immediately greeted with the electronic components. To make my life easier, I did decide to remove the filament stand, however this is not a necessary step.
Once the electronics were visible I removed the two screws holding them in place so that I could get a better look at the housing that already existed on the machine. The first step was the remodel the area where the sensor would be sitting and once that portion as completed I was then able to focus on the entryway for the filament. The issue with the stock version is that the angles were too sharp and this was what was causing the large amount of friction. Also the alignment was slightly off and this caused the filament to get stuck in the switch portion of the mechanism. In order to address these issues, I created a gradual entry way for the filament the pass through and changed the point where the filament intersected with the switch. This produced a much more gradual entrance which reduced the friction significantly.
With this out of the way it was now time to create the connection points in which the two halves of the sensor would meet and combine to make the shell. I then added the bolt indents to further make this easier to assemble. So after a couple of prototypes I finally had the final version that I would be installing on my machine.
IF you decide to install this one your own machine you’ll need to do the following. You’ll need to add the two screws to hold the switch in place after which you’ll add the screws and bolts for the housing. In my case I only had longer screws available so I ended up only installing two of these across from each other. This also allowed me to place a much longer screw going in the opposite direction to attach this to the sensor mount. I added a bolt behind it just to make sure that it didn’t come off latter on. With that completed I installed it onto the machine and quickly tested it with both flexible and PLA filament. After doing my first print I can say that it’s still working quite well and I’m happy with the results. This was the resulting test cube which was printed with a 0.8 nozzle and scaled to 130%.
Although this may seem like a simple mod I found this to be one in which I appreciate the most since the friction being produced has caused my filament to break in mid print on certain occasions. Since the filament sensor is mounted away from the nozzle it doesn’t register a break in the filament and keeps on printing which has been a issue in the past. With modification in place it should prevent this from reoccurring in the future.